Apple Final Cut Pro Bedienungsanleitung PDF herunterladen

Uncompressed SD Editing

Using Final Cut Pro

This document outlines the recommended system components and setup for optimal

performance of uncompressed SD editing using Final Cut Pro.

Editing in high data rate formats such as uncompressed SD can stress all aspects

of a computer system. This means it is important to make sure that each system

component is adequate in order to achieve maximum overall system performance.

These components include the computer, RAM, and disk storage subsystem. For this

reason, the following hardware is suggested in order to achieve the maximum

performance for uncompressed SD editing.

Hardware

•

1 x Dual 2.0 GHz or faster Power Mac G5 with at least 1 GB of memory. The system

should be configured with either the ATI Radeon 9800 or NVIDIA GeForce FX 5200

Ultra or later graphics card.

•

1 x 2.52 TB Xserve RAID. The Xserve RAID should be built using the CTO option with

upgraded RAM on the controllers to at least 512 MB.

•

1 x Apple Fibre Channel PCI Card

•

1 x Apple ProIO FireWire capture/playback device or equivalent PCI capture/

playback card (such as AJA Io, Kona SD, or Pinnacle CineWave)

Software

•

Mac OS X version 10.3 Panther or later

•

Final Cut Pro 4.1 or later

•

Apple ProIO drivers v1.0.2 or later

•

QuickTime 6.4

UncompressedSDEditing Page 1 Thursday, November 6, 2003 4:06 PM

1 2 3

1 1 Uncompressed SD Editing Using Final Cut Pro This document outlines the recommended system components and setup for optimal performance of

2 Hardware Setup Once you have properly installed all the pieces listed earlier, follow the steps below to configure the Xserve RAID hardware compo

Setting Up Final Cut Pro Once you have completed the steps to set up your Xserve RAID, it is ready to be used by Final Cut Pro. You should now conf

Keine Kommentare

Apple Final Cut Pro Bedienungsanleitung