Apple Mac Pro (Processor Cage Fans, Front and Rear Repla Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Computers Apple Mac Pro (Processor Cage Fans, Front and Rear Repla herunter. Apple Mac Pro (Processor Cage Fans, Front and Rear Replacement) User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 15
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
073-1254 Rev. A 1
© 2009 Apple Inc. All rights reserved.
 Mac Pro
First Steps
Shut down computer.1
2
Wait 10 minutes.
Warning: Parts inside
computer can be very
hot. Allow computer
to cool down before
continuing.
Unplug all external 3
cables except power
cord.
Touch metal PCI cover 4
on back of computer.
Unplug power cord.5
Opening the
Computer
Hold side access 1
panel and lift latch on
back of computer.
Warning: Edges of
access panel and
enclosure can be
sharp. Be careful
when handling.
Remove access panel 2
and place it on at
surface covered by
soft, clean cloth.
Processor Cage Fans, Front and Rear
Replacement Instructions
Note: Follow these instructions carefully. Failure to do so could damage your equipment and
void its warranty.
Seitenansicht 0
1 2 3 4 5 6 ... 14 15

Inhaltsverzeichnis

Seite 1 - Replacement Instructions

073-1254 Rev. A 1© 2009 Apple Inc. All rights reserved. Mac ProFirst StepsShut down computer.1 2 Wait 10 minutes.Warning: Parts inside computer c

Seite 2 - 1 Make sure latch on

073-1254 Rev. A 10© 2009 Apple Inc. All rights reserved.24 Lift cage out of enclosure.Processor Cage Fans25 Locate processor cage fans.

Seite 3 - 4 Using Phillips #1

073-1254 Rev. A 11© 2009 Apple Inc. All rights reserved.26 Release fan cables from clips on bottom of processor cage.27 Release 4 latches on front

Seite 4 - 073-1254 Rev. A 4

073-1254 Rev. A 12© 2009 Apple Inc. All rights reserved.Installing the Replacement FansI1 Position front fan in cage.Slide fan back until it 2 en

Seite 5

073-1254 Rev. A 13© 2009 Apple Inc. All rights reserved.Processor CageImportant: Before you re-install cage into enclosure, fans must be inserted

Seite 6 - 11 Press down and

073-1254 Rev. A 14© 2009 Apple Inc. All rights reserved.Processor TrayHolding tray by 13 latches, lower it into processor cage.Make sure latches a

Seite 7 - 14 Locate PCIe fan

073-1254 Rev. A 15© 2009 Apple Inc. All rights reserved.Hard Drive19 Replace hard drive in far-left drive bay.Closing the Computer1 Replace access

Seite 8 - 17 Locate processor

073-1254 Rev. A 2© 2009 Apple Inc. All rights reserved. Required ToolsPhillips #2 screwdriver • RIght-angle, 2.5 mm • hex driverFlatblade screwdri

Seite 9 - 073-1254 Rev. A 9

073-1254 Rev. A 3© 2009 Apple Inc. All rights reserved.Graphics Card3 Locate graphics card in slot 1.4 Using Phillips #1 screwdriver, loosen 2 c

Seite 10 - 25 Locate processor cage

073-1254 Rev. A 4© 2009 Apple Inc. All rights reserved.Note: Card is held in place by retention bar. Following two steps explain how to release ba

Seite 11 - 27 Release 4 latches on

073-1254 Rev. A 5© 2009 Apple Inc. All rights reserved.8 Holding card by top corners, pull it up out of slot.Remove card from 9 computer.Checklis

Seite 12 - 073-1254 Rev. A 12

073-1254 Rev. A 6© 2009 Apple Inc. All rights reserved.Processor Tray10 Locate processor tray.11 Press down and release 2 latches on front of pro

Seite 13

073-1254 Rev. A 7© 2009 Apple Inc. All rights reserved.12 Holding tray by latches, lift it out of computer.Place tray DIMM side 13 up on soft, cle

Seite 14 - Graphics Card

073-1254 Rev. A 8© 2009 Apple Inc. All rights reserved.15 Remove 2 screws.Slide fan up and out 16 of computer.Processor Cage17 Locate processor ca

Seite 15 - 19 Replace hard drive in

073-1254 Rev. A 9© 2009 Apple Inc. All rights reserved.18 Disconnect 3 cables from logic board.Using long-handled 19 Phillips #1 screwdriver, loos

Kommentare zu diesen Handbüchern

Keine Kommentare