Apple Xserve G5 Bedienungsanleitung PDF herunterladen (Seite 73)

Xserve G5 Take Apart - 71

Logic Board

Important: When replacing the logic board, make sure the board’s connectors ﬁt through

the appropriate openings in the server’s back panel. Take special care to ﬁt the clear

plastic system identiﬁer button through its opening. (The system identiﬁer button is located

low on the back panel, to the left of center.)

Caution: Be careful not to ﬂex the logic board, which could damage the board or its

components. To minimize ﬂexing, always grasp the logic board by its long edges when

removing or installing it.

After installing a replacement logic board, be sure to transfer any PCI cards, risers, and

DIMMs to the new board. You must also remove the battery insulator tab from the battery

holder on the new board.

Note: Replacing the logic board in the server changes its Ethernet ID number. The new

number is printed on an Ethernet label packaged with the replacement logic board. After

installing the new logic board, place the new Ethernet label over the original Ethernet

number on the server’s back pane

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 93 94

Keine Kommentare

Apple Xserve G5 Bedienungsanleitung Seite 73