Apple Ethernet CS Twisted-Pair Card Installationsanleitung PDF herunterladen (Seite 32)

2-22 Installing Asanté MacCon Cards

To install the MacCon+ SE card in the Macintosh SE, perform the fol-

lowing steps:

Figure 2-16 Installing the MacCon SE daughter controller card

and daughter card

Caution

Be very careful opening and working inside the Macintosh SE.

1 Power down the Macintosh. Disconnect and remove the

power cable.

2 Lay the Macintosh SE ﬂat on its face.

3 Open the case very carefully and remove the access port

cover.

4 Make sure you are grounded: check that your anti-static

wrist strap is properly attached to your wrist and to the

Macintosh chassis.

Motherboard

Expansion slot

MacCon+ SE

controller card

Hard drive

connector (50-pin)

MacCon+ SE

daughter card

Floppy drive

connectors (20-pin)

Power supply connector

Speaker connector

disconnect

4 wires

MacCon cable

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 64 65

Keine Kommentare

Apple Ethernet CS Twisted-Pair Card Installationsanleitung Seite 32