Apple Xserve Betriebsanweisung PDF herunterladen (Seite 19)

Xserve G5 Take Apart -

RAID Card and Standoff

Replacing Standoff

Follow these steps to replace a missing RAID card standoff..

1. Mark the postion of the standoff, which will be installed in the hole in the corner of the

card where shown above. Using your ﬁngernail ,mark the position of the standoff on

the black sheet of mylar insulation beneath the RAID card.

2. Remove the card from the PCI slot and using the square of double-stick tape included

with the standoff, tape the black mylar insulation sheet to the bottom of the server.

Adhere the double-stick tape to the metal chasis ﬂoor directly below the spot you

marked.

3. Remove the paper covering from the underside of the standoff’s base. Re-install the

card in the bottom PCI slot with the standoff in place, and press the standoff against

the mylar sheet.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 94 95

Keine Kommentare

Apple Xserve Betriebsanweisung Seite 19