Apple Final Cut Pro 5 Bedienungsanleitung PDF herunterladen (Seite 19)

Getting Started

Installing Final Cut Pro

Installation places the Final Cut Pro application and its components on your hard disk.

Installation of certain software components is determined by the type of capture hardware

you will be using with Final Cut Pro. If you have not yet installed and conﬁgured the

additional hardware you will be using with your computer, read the section “Hardware Setup

and Conﬁguration” on page 20. If you already have a system conﬁgured with capture

hardware and a camcorder or deck, proceed with the installation instructions in this section.

Insert the Final Cut Pro

CD into your CD-ROM drive.

Double-click the Install Final Cut Pro icon.

Choose a destination disk from the pop-up list and click Select.

Note:

Final Cut Pro can only be installed on a hard disk with Mac OS 8.5 or later.

Read the Software License Agreement and click Continue.

Click Agree to continue with the installation.

Click Disagree to cancel the installation.

Specify the video capture hardware you will be using:

Select Pinnacle Systems Targa Series if you will use a Targa video capture card.

Select DV (digital video) if you will use Apple FireWire and DV devices. When you select

DV, your default video frame size is set to 720 x 480.

Note:

Selecting DV will install FireWire extensions in your System Folder. These

extensions are optimized for Final Cut Pro. If you have existing FireWire extensions in

your System Folder that you want to retain, move them out of the Extensions folder

before you continue.

Select None/Don’t Know if you will use hardware other than DV or Pinnacle Systems

Targa.

To specify a default video frame size (Pinnacle Systems Targa only):

Select NTSC Standard for a 640 x 480 frame size.

Select NTSC (CCIR 601) for a 720 x 486 frame size.

To specify the type of video source connection:

Select Composite to sample video over a single cable using a BNC or RCA connector.

Select S-Video to sample video over a single cable using a 4-pin S-video connector.

Select Component to sample video over three cables using Betacam (r-y, b-y, Y)

Component BNC or RCA connectors.

Click Start to install Final Cut Pro.

Restart your computer.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 375 376

Keine Kommentare

Apple Final Cut Pro 5 Bedienungsanleitung Seite 19