Apple Mac OS X Server System Imaging and Software Update Administration For Version 10.4 or Later Bedienungsanleitung PDF herunterladen (Seite 44)

44 Chapter 3 Setting Up NetBoot Service

From the Command Line

You can also configure NetBoot service using the serveradmin command in Terminal.

See the system image chapter of the command-line administration guide.

Starting NetBoot and Related Services

NetBoot service uses AFP, NFS, DHCP, Web, and TFTP services, depending on the types

of clients you’re trying to boot (see “Network Service Requirements” on page 24).

You can use Server Admin to start AFP, DHCP, Web, and NetBoot. NFS and TFTP start

automatically.

Note: NetBoot does not start automatically after server restart when you enable

NetBoot service in the Setup Assistant when you first install the server software.

Only the required share points are set up.

To start NetBoot service:

1 Open Server Admin.

2 If you’ll be booting diskless Mac OS X clients, start AFP service.

Select AFP in the Computers & Services list and click Start Service.

3 If your server is providing DHCP service, make sure the DHCP service is configured and

running. Otherwise, DHCP service must be supplied by another server on your network.

If your NetBoot server is also supplying DHCP service, you might get better

performance if you configure your server as a gateway. That is, configure your subnets

to use the server’s IP address as the router IP address.

4 Select NetBoot in the Computers & Services of Server Admin.

5 Click Settings.

6 Select which network ports to use for providing NetBoot service.

You can select one or more network ports to serve NetBoot images. For example, if you

have a server with two network interfaces, each connected to a network, you can

choose to serve NetBoot images on both networks.

7 Click Images.

8 Select the images to serve.

9 Click Save.

10 Click Start Service.

From the Command Line

You can also start NetBoot and supporting services using commands in Terminal.

For more information, see the system image chapter of the command-line

administration guide.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 88 89

Keine Kommentare

Apple Mac OS X Server System Imaging and Software Update Administration For Version 10.4 or Later Bedienungsanleitung Seite 44