Apple Xserve (Early 2008) DIY Procedure for Enclosure Bedienungsanleitung PDF herunterladen (Seite 87)

Xserve (Late 2006/Early 2008) Power Distribution Board Replacement Instructions 5

Caution: The power distribution board cable connectors are tight and can be dicult to

disconnect. You may want to use a small atblade screwdriver to gently yet rmly pry outwards

on the cable connector while depressing the cable connector latch with your thumb and

forenger to separate the connectors.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

Caution: Try not to completely remove the screws from the airow duct. Tiny black rubber

washers hold these screws captive on the underside of the airow duct. If the screws are

completely removed, these washers can easily fall into the enclosure and become lost.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 168 169

Keine Kommentare

Apple Xserve (Early 2008) DIY Procedure for Enclosure Bedienungsanleitung Seite 87