Apple Xserve (Original) Bedienungsanleitung PDF herunterladen (Seite 29)

Installing Your Server in a Rack 29

Note: When installing a drive module for the ﬁrst time, remove the blank drive module and

save it for possible future use. This unit is necessary for appropriate cooling of the server in a

drive bay that has no drive module in it.

When you’ve installed optional items, you’re ready to connect the server to the rack. If you

have a four-post rack or cabinet, proceed to the next section, “Install the Server in a Four-Post

Rack or Cabinet” on page 29. If you have a two-post rack, go to “Install the Server in a Two-

Post (Telco) Rack” on page 37.

Install the Server in a Four-Post Rack or Cabinet

A four-post rack can be open or enclosed in a cabinet. Examples of both racks are shown

below. You follow the same steps to attach the server to either of these racks. For a cabinet,

however, you may have to remove the door before installing the server.

Important Be sure to check the documentation for your rack for any speciﬁc mounting

instructions.

Four-post open rack

Four-post cabinet rack

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

Keine Kommentare

Apple Xserve (Original) Bedienungsanleitung Seite 29