Apple Xserve (Early 2008) Bedienungsanleitung PDF herunterladen (Seite 24)

24 Chapter 2 Installing or Replacing Components

Installing or Replacing an Apple Drive Module

If you’re not using an Xserve RAID card, the drive modules in the Xserve are hot-

pluggable, so you can add, remove, or replace them while the Xserve is operating. A

status light on the drive handle indicates when it’s safe to remove a drive without risk

to the information stored on it.

If you are using an Xserve RAID card, you can add, remove, or replace failed hard drives

while the Xserve is operating. However, to replace an entire RAID set, turn off the

Xserve before adding, removing, or replacing drives.

About Drive Modules for the Xserve

The Xserve accepts both SAS (Serial Attached SCSI) and SATA (Serial ATA) drive

modules. If you are using an Xserve RAID card, use drive modules that are the same

size and type.

To install or replace a drive module:

1 If the Xserve case is locked, use the enclosure key to unlock the security lock on the

front panel.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Keine Kommentare

Apple Xserve (Early 2008) Bedienungsanleitung Seite 24