Apple Xserve (Early 2008) Bedienungsanleitung PDF herunterladen (Seite 36)

36 Chapter 2 Installing or Replacing Components

To install memory:

1 Review the memory installation rules and make sure you have the right type of DIMMs.

2 Shut down the Xserve and unplug all cables.

Important: Be sure the Xserve is turned off and the power cords are unplugged before

you install or remove memory.

3 Remove the Xserve from the rack and open it. For instructions, see “Opening and

Closing the Xserve” on page 30.

4 Open the ejectors on a slot by pushing them outward.

Important: Don’t touch the gold connectors on the DIMMs.

5 Without touching its gold connectors, align a DIMM in the slot and push straight down

on both ends until the DIMM is seated and the ejectors snap upright.

6 Repeat for the second DIMM of the pair and for additional pairs.

Important: Be sure to add DIMMs in the order shown in the illustration.

WARNING: Always wait 5 to 10 minutes for the Xserve to cool down before you try to

install memory. DIMMs that are already installed and other components near the

DIMM slots may be very hot.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Keine Kommentare

Apple Xserve (Early 2008) Bedienungsanleitung Seite 36