To reset to factory defaults
1 On the control panel of the HP all-in-one, press the Setup button.
2 Press 8, and then press 2.
This displays the Network menu and then selects Restore Network Defaults.
3 Press 1 to confirm.
Turn the wireless radio on and off
The wireless radio is on by default, as indicated by the blue light on the front of the
HP all-in-one. In order to stay connected to the network, the radio must stay on.
However, if your HP all-in-one is not connected to a network and you only have a USB
connection, the radio is not used. In this case you might want to turn the radio off.
To turn the wireless network radio on
1 On the control panel of the HP all-in-one, press the Setup button.
2 Press 8, press 5, and then press 1.
To turn the wireless network radio off
1 On the control panel of the HP all-in-one, press the Setup button.
2 Press 8, press 5, and then press 2.
Advanced network settings
The Advanced Setup options enable you to change link speed, IP settings, and
memory card security.
Note Unless you are an advanced user, you should not change any of these settings.
Set link speed
You can change the speed at which data is transmitted over the network. The default is
Automatic.
To set the link speed
1 On the control panel of the HP all-in-one, press the Setup button.
2 Press 8, and then press 3.
This displays the Network menu and then selects Advanced Setup.
3 Press 1 to select Change Link Speed.
4 Press the number next to the link speed:
– 1. Automatic
– 2. 10-Full
– 3. 10-Half
– 4. 100-Full
– 5. 100-Half
Change IP settings
The default IP setting is Automatic. However, if necessary, you can manually change
the IP address, subnet mask, or the default gateway. To see the IP address and subnet
mask of your HP all-in-one, print a network configuration page from your HP all-in-one
Chapter 8
30
Kommentare zu diesen Handbüchern