Apple Processor Cage and Clips Installationsanleitung PDF herunterladen (Seite 76)

Figure 50 Generating SP ID Page

NOTE: During the SP Setup process, the StoreServ must be powered on, connected to the

same network subnet as the SP, and non-initialized to allow the SP to verify the StoreServ

serial number.

3. After the SP ID is generated, click Next.

Configure SP Networking

To complete this section, use the completed installation checklist from HP 3PAR StoreServ 7000

Site Planning Manual as reference.

NOTE: For additional information and help, use the HP 3PAR SmartStart online help (accessible

by pressing F1).

1. Enter the SP information for the following fields:

• Service Processor hostname

• IP Address

• Subnet Mask

• Gateway

76 Setting Up the Service Processor and Storage System

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 116 117

Keine Kommentare

Apple Processor Cage and Clips Installationsanleitung Seite 76