Apple Xserve Einstellungsanleitung PDF herunterladen (Seite 19)

Xserve RAID Take Apart -

Processor

Procedure

1. Remove the two screws on the front of the controller module case.

2. Slide out the bottom half of the case.

Note:

The controller card is attached to the bottom of the controller module case. Do

not attempt to separate the card from the bottom case.

3. Place the controller card on a ﬂat sturdy surface. Using needlenose pliers, compress

the two plastic pegs holding the processor in place. Then, holding the processor by

the edges, pull it straight up to disconnect it from the controller card.

Important:

After you replace the processor, be sure to replace the Ethernet label on the

controller module with the Ethernet label included with the new processor.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 68 69

Keine Kommentare

Apple Xserve Einstellungsanleitung Seite 19