Apple Xserve (Early 2008) DIY Procedure for Light Pipe A Bedienungsanleitung PDF herunterladen

 Xserve (Early 2008)

073-1170 Rev. A

Light Pipe Assembly

Replacement Instructions

Follow the instructions in this document carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Online instructions are available at http://www.apple.com/support/diy/.

Working Safely Inside the Xserve

Always touch the Xserve enclosure to discharge static electricity before you touch any

components inside the Xserve. To avoid generating static electricity, do not walk around the

room until you have nished working inside the server and have replaced the cover. To minimize

the possibility of damage due to static discharge, wear an antistatic wrist strap while you work

inside the Xserve.

Warning: Always shut down the Xserve and disconnect the power cords before opening

it to avoid damaging its internal components or the components you are installing. Don’t

open the server while it is turned on. Even after you shut down the Xserve, its internal

components can be very hot. Let it cool before you open it.

Tools Required

The only tool required for this procedure is a Phillips screwdriver.

Removing the Xserve from a Rack

Alert users that the server will be unavailable for a period of time. 1.

Shut down the Xserve (see the Xserve User’s Guide for help) and then wait to let the Xserve 2.

internal components cool.

Warning: Always shut down the Xserve before opening it to avoid damaging its internal

components or the components you want to install or remove. Don’t open the Xserve

or try to install or remove items inside while it is turned on. Even after you shut down

the Xserve, its internal components can be very hot. Let it cool down for 5 to 10 minutes

before you open it.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Light Pipe Assembly

 Xserve (Early 2008)073-1170 Rev. ALight Pipe AssemblyReplacement InstructionsFollow the instructions in this document carefully. Failure to follow t

Seite 2 - Opening the Xserve

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 2Unplug all cables from the Xserve. 3. Note: If you have trouble releasing a cable f

Seite 3

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 3Removing the Installed Light Pipe AssemblyFrom behind the front bezel, locate the f

Seite 4

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 4Grasping the ends of the light pipe assembly, pull it out of the front bezel. 4. I

Seite 5

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 5Leave the power button and system identier button on the server enclosure, but not

Seite 6 - Closing the Xserve

Xserve (Early 2008) Light Pipe Assembly Replacement Instructions 6Closing the XserveReplace and secure the cover.1. Slide the Xserve back into the ra

Kommentare zu diesen Handbüchern

Keine Kommentare

Apple Xserve (Early 2008) DIY Procedure for Light Pipe A Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Software Apple Xserve (Early 2008) DIY Procedure for Light Pipe A herunter. Apple Xserve (Early 2008) DIY Procedure for Light Pipe Assembly User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Apple Xserve (Early 2008) DIY Procedure for Light Pipe A