Apple G5 G5 Betriebsanweisung PDF herunterladen (Seite 37)

Chapter 3 Installing Your Server in a Rack 37

2 Secure the server in the rack by tightening the thumbscrews on the front.

Important: Take care not to apply too much pressure on the thumbscrews if you use a

power screwdriver or drill. The torque applied to the thumbscrews should not exceed

6.0 inch-pounds, and the rotation speed should not exceed 200 rpm.

3 Remove the optical drive protector from its slot.

Be sure to store this protector in a safe place and always reinsert it before moving the

server to another location.

4 To further secure the server and prevent removal of the drive modules, use the

enclosure key (supplied with the server) to fasten the security lock on the front panel.

(See the illustration above.)

5 If you’ve installed the server in a cabinet, replace and close the cabinet door.

Once the server is secured in the rack or cabinet, you can attach the cable-

management arm and cables for the server’s connections.

Install the Cable-Management Arm and Cables

Xserve has a cable-management arm that allows you to open the server without

disconnecting cables. In addition, this device supports the cables and relieves strain on

the server’s back-panel connectors.

Note: Always use the long power cord if you plan to attach the cord to the cable-

management arm.

If you are not installing the cable-management arm, see “Connect Cables Directly to

the Server” on page 54 for details on connecting cables.

Tighten the two thumbscrews

to secure the server in the rack.

To secure the drive

modules in the server,

use the enclosure key

to lock them in place.

Remove the plastic optical

drive protector. Save it and

reinstall it if you ever move

the server to another location.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 95 96

Keine Kommentare

Apple G5 G5 Betriebsanweisung Seite 37