Apple G5 G5 Betriebsanweisung PDF herunterladen (Seite 40)

40 Chapter 3 Installing Your Server in a Rack

Moving the server forward allows you to check the position of the cable-management

arm after you mount it.

2 Position the cable-management arm so that the short part is closer to the server’s back

panel and the elongated holes on the long part align with the holes on the brace

attached to the left post.

3 While holding the arm in the correct position, disconnect the upper mounting screw

that holds the left brace to the left post, place the corresponding hole of the cable-

management arm’s long side over that opening, and reconnect the mounting screw.

Important: Be sure to support the server from below as you remove and replace the

mounting screws one at a time.

4 Disconnect the lower mounting screw, line up the corresponding part of the arm, and

reconnect the mounting screw.

Support the server from below while doing this step.

5 Verify that the arm’s position is correct by moving the arm inward so that it swings

under the cover of the server.

If the arm hits the cover or is not level as you move it, you need to adjust its position by

unscrewing one or both mounting screws and moving the arm up or down slightly

until it is level and moves smoothly under the server’s cover.

Place the cable-management arm over the U-shaped

brace, and secure it to the rack. It is important that

you remove and then reinstall one screw at a time

so that the server is supported at all times.

Remove and then reinstall the mounting screws one at a time.

Support the server from below while

attaching the cable-management arm.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 95 96

Keine Kommentare

Apple G5 G5 Betriebsanweisung Seite 40