Apple G5 G5 Betriebsanweisung PDF herunterladen (Seite 53)

Chapter 3 Installing Your Server in a Rack 53

4 Secure the server in the rack by tightening the thumbscrews on the front.

Important: Take care not to apply too much pressure on the thumbscrews if you use a

power screwdriver or drill. The torque applied to the thumbscrews should not exceed

6.0 inch-pounds, and the rotation speed should not exceed 200 rpm.

5 Remove the optical drive protector from its slot.

Be sure to store this protector in a safe place and always reinsert it before moving the

server to another location.

6 To further secure the server and prevent removal of the drive modules, use the

enclosure key (supplied with the server) to fasten the security lock on the server’s front

panel. (See the illustration above.)

Note: You cannot use the cable-management arm on an Xserve system that is installed

in a two-post rack.

Tighten the two thumbscrews

to secure the server in the rack.

To secure the drive modules in

the server, use the enclosure

key to lock them in place.

Remove the plastic optical

drive protector. Save it and

reinstall it if you ever move

the server to another location.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 95 96

Keine Kommentare

Apple G5 G5 Betriebsanweisung Seite 53