Apple G5 G5 Betriebsanweisung PDF herunterladen (Seite 32)

32 Chapter 3 Installing Your Server in a Rack

When you’ve installed optional items, you’re ready to connect the server to the rack. If

you have a four-post rack or cabinet that is 29–36 inches deep, proceed to “Installing

the Server in a Four-Post Rack or Cabinet” on page 32. If you have a short rack that is 24

or 26 inches deep, go to “Installing the Server in a Short Four-Post Rack” on page 46. If

you have a two-post rack, go to “Installing the Server in a Two-Post (Telco) Rack” on

page 51.

Installing the Server in a Four-Post Rack or Cabinet

A four-post rack can be open or enclosed in a cabinet. Examples of both racks are

shown below. You follow the same steps to attach the server to either of these racks.

For a cabinet, however, you may have to remove the door before installing the server.

Important: Be sure to check the documentation for your rack for any specific mounting

instructions.

Once you’ve marked the exact position for the server on the rack, you’re ready to attach

the server. Here is an overview of the procedure.

• Connect the cover of the server to the front of the rack.

• Assemble the rear mounting hardware.

• Connect the rear mounting hardware to the server enclosure.

• Slide the server into the cover and secure it.

• Install the cable-management arm.

Note: You cannot use the cable-management arm in a short rack, 24 or 26 inches

deep. For details on installing the server in a short rack, see “Installing the Server in a

Short Four-Post Rack” on page 46.

Four-post open rack

Four-post cabinet rack

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 95 96

Keine Kommentare

Apple G5 G5 Betriebsanweisung Seite 32